Friday, September 12, 2014

Inside the "$10" Rockchip TV dongle

Last year Rockchip demoed a "$10" Miracast/DLNA TV dongle.  The $10 was not a target retail price, but probably the BOM cost.  They can be found for under $20 including shipping from China.  I bought one and posted a review of the Miracast and DLNA functionality.  In this post I'll document a basic teardown of the dongle, along with instructions on setting up a root console connection.

There are no screws holding the dongle together; the top and bottom of the case simply snap together.  The RK2928 is underneath a small heat spreader.  Next to it is a Spectek PE937-15E 256MB DDR3 chip. the rest of the components appear to be for power regulation.

On the bottom of the board is a Winbond serial flash chip and a Realtek rtl8188ETV USB wifi module.  Small pads labeled TX, RX, and GND are visible near the edge of the board.  They are obviously for a serial console.  I soldered some 30AWG wire-wrap wire to the pads, and to some 0.1" header pins.  With my soldering iron I melted an opening in the plastic case where I hot glued the header pins.

After putting the dongle back together, I connected the serial console to a USB-TTL serial adapter, and powered up the module.  I could see the Rx LED on the serial module flickering, indicating it was receiving console output data.  I started a terminal program, and was not seeing anything when I tried 9600 and 19,200bps.  Then I remembered my logic analyzer has a serial baud rate detection.  I hooked it up, ran a capture while the dongle was booting, and found the baud rate was 115,200kbps.

After setting the terminal program to 115,200, I could see what I recognized as the console output of a Linux kernel.  When the output stopped, I saw a "#" indicating a root shell prompt - no password required.  However the prompt wouldn't last long before the dongle seemed to reboot and repeat the start-up console output.

I first checked the board to make sure nothing was shorting from the connections I made to the serial port pads.  I then used a home-made USB cable with exposed power connections to measure the voltage.  I found the voltage was briefly dipping below 4.5V when the dongle was rebooting.  The dongle's peak power draw was too much for the PC USB port.  My solution was a 220uF capacitor connected to my home-made USB cable.  With the capacitor added, the voltage stayed above 4.8V, and there were no reboots.

The Linux installation seems to be a stripped-down android image rather than a standard linux distribution.  While the 256MB of RAM is ample for an embedded linux distribution, the 16MB of flash makes installing something like Picuntu Linux very difficult.


  1. That's a cool piece of electronic detective work! Would you say its common for such devices to go straight to a terminal without a login?

    1. I suspect most manufacturers using the RK2928 use the same modified android build as it is likely provided by Rockchip.

  2. Does it has USB support somewhere in the kernel?

    This page says the SOC does not have a USB stack:

    But on the other side the page also says it can boot from USB.

    1. There is USB support since it shows up as a rockchip device when plugged into USB. Whether the USB support is in the boot firmware or in the Linux kernel I'm not sure.
      I haven't done much more with it (other than using it for playing movies), as I think RaLink router sticks (which can run OpenWRT) make a better (and cheaper) hackable wireless linux platform.